"How-to" - PSX-R Modification

"how to"'s & Cyrus brochures etc
User avatar
Robert
Administrator
Administrator
Posts: 2651
Joined: Mon Nov 04, 2002 12:53 am
Contact:

"How-to" - PSX-R Modification

Postby Robert » Sun Nov 13, 2005 9:52 pm

How to modify your Cyrus 3 / 3i / 7 / Power to accept a PSX-R

Start with your Cyrus unit upside down, with the front panel towards you.

Image

Remove all screws with a Torx 10 screwdriver, and remove bottom plate.

Image

Behind the Toroidal transformer are 2 pairs of snap-on connectors.

Image

Disconnect and swap the blue and yellow connectors (left pair).
Disconnect and swap the grey and red connectors (right pair).
Note your colours may vary, but you always swap the left and right wires.

Image

Replace bottom plate.

Attach PSX-R umbilical cord to back of Cyrus unit, and power on both units. Check there are no flashing warning lights.

N.B. Cyrusunofficial takes no responsibility for any damage caused in attempting to undertake this modification.
home office: Dell laptop running JRriver MC22 / Meridian Explorer / AKG 550's
music room: PC transport running JRiver MC22 / Naim DAC-V1 / Naim Supernait 2 / Neat Motive SX2
kitchen: Naim Unitiqute 2 / Naim NAP100 / Totem Dreamcatchers

User avatar
Robert
Administrator
Administrator
Posts: 2651
Joined: Mon Nov 04, 2002 12:53 am
Contact:

Re: How-to" - PSX-R Modification

Postby Robert » Thu Feb 10, 2011 9:23 am

see also:

Image
Last edited by Robert on Thu Feb 10, 2011 10:34 am, edited 1 time in total.
home office: Dell laptop running JRriver MC22 / Meridian Explorer / AKG 550's
music room: PC transport running JRiver MC22 / Naim DAC-V1 / Naim Supernait 2 / Neat Motive SX2
kitchen: Naim Unitiqute 2 / Naim NAP100 / Totem Dreamcatchers